HOW TO D.I.Y. THE WELL AWP/AW.338
​BEARING TRIGGER

Want to make your WELL AWP/AW.338 more accurate, in addition to modified T-N.T. APS-X HOP-UP SYSTEM, there are other ways?

Of course you need the BEARING TRIGGER!!

Let's take a look how to DIY the BEARING TRIGGER on your AWP/AW.338!
(The following are modified upgrade parts as an example, if you just want to DIY the bearing trigger but don't want to change other parts, methods and steps are the same.)

1. This time we use the modified trigger assembly as an example.
(steel trigger unit)

2. Prepare 2*5 bearing x2 and replace it.

3. Steel sear set 
Top : Original.
Under : Modified the angle and polishing ​like the photo.

Steel sear set -
Left : Original.
Right : Polished the contact surfaces like the photo.

Left : Original.
Right : Polished the contact surfaces of trigger and sear.

4.Replace the softer spring of sear side. (top one is original sping)

5. ​Lubrication on every contact surface, than assemble all parts back.