對應型號Corresponding model： ●WE G series G17/18/19/23/34/35 (if G26/27 please specify in the order, the chamber is shorter) ●MARUI original HOP-UP unit, not suitable for New ver. HOP-UP unit (side adjustment) ●VFC older ver. HOP-UP unit (similar to TM spec.), not suitable for New Front-guide ver. HOP-UP unit
本產品提供以下可供選購： ●單HOP-UP座套組 (標配為TL膠皮或可更換T-HOP膠皮)。 ●HOP-UP總成套組 (標配為TL膠皮、精密管、HOP座)。 ※220mm以下內管皆無氣墊槽設計※ ※可安裝於海神 Orion performance 2代 HOP座(溝槽需稍微打磨)※ - 【TAIWAN T-N.T. STUDIO】2023 New release products 『THE ONE』 WE GLOCK series GBBP dedicated One-piece TDC HOP-UP chamber assembly / Complete set
Features : 1. The body of the HOP chamber is designed in one piece and made of alloy precision casting. The rubber-covered design has excellent air-tightness and the installation steps are simple and fast.
2. The part that is most likely to break on the side of the HOP chamber : the sliding auxiliary positioning bump is replaced by a steel PIN, which is durable and will never break.
3. Change the HOP-UP adjustment method to TDC : ●It can provide the average down force of the adjustment ring, and completely get rid of the problem of uneven force on the left and right of the traditional down pressure steel design. ●HOP step-less adjustment allows for more fine-tuning; a larger HOP adjustment range makes it easy to control whether you use light flicks or heavy flicks. ●Adjustment ring is designed with a push-back spring to keep the HOP-UP not easy to loosen, effectively maintaining the ideal amount of depression after adjustment.
●This product provides: single HOP-UP chamber set (standard configuration is TL-HOP bucking, or replaceable T-HOP rubber) and Complete set (standard configuration is TL-HOP bucking, precision inner barrel, HOP chamber) available buy. ※Length below 220mm without air-cushion groove design※ ※lt can be installed on the Orion performance No.2 HOP-UP chamber (the groove needs to be slightly polished).※ ※All retrofit kits are assembled by our professional technicians, but there may still be slight tolerances between different batches of airsoft guns. It is recommended that you must have relative DIY ability before purchasing.※
▲NOTICE▲ 請勿過於用力調整，避免斷裂。 Please don't adjust too hard to avoid breakage.
※短內管無氣墊槽設計※ ※Shorter barrel have no Air-cushion design (Shorter than 220mm)※
【T-N.T. THE ONE-WE GLOCK HOP-UP chamber Installation Precautions】
The early inner barrels of other brands or imported brands have smaller windows (the lower pressure area inside the rubber is smaller). The adjustment ring and the pressure area inside the rubber will interfere, resulting in insufficient pressure. Players are prone to forcefully lock the adjustment ring in order to increase the amount of pressure, eventually causing the adjustment ring to break.
The precision inner barrels on the market today have larger windows (the internal pressure area of the rubber is larger), which can provide a larger pressing area and amount. It is recommended that players who use early inner barrels with smaller windows repair the windows make it larger, then install T-N.T. THE ONE-WE GLOCK HOP-UP chamber, to avoid breaking the adjusting ring.